You are here: Configuration and Operations > Administration Tab > Updates

Updates

Update Appliance

Updates can be downloaded from the Tenable Support Portal located under Updates on the Tenable Appliance download page. The update(s) should be stored locally before performing the installation. Update packages can be applied to either the hardware or VM version of the appliance, unless otherwise noted.

To apply the update, go to the location where the update file was saved and click Apply Update. A green banner will display if the update is successful. A red banner will display if the update is unsuccessful stating the problem that caused the error.

The update can be confirmed by viewing the version information in the Appliance tab.

Update Availability Detection

The Appliance has the ability to check for updates. When an update has been detected, a banner will appear at the top of the interface until it is installed.

Click the Configure Automatic Update Detection button to set up automatic checks. The system is set to Apply Updates Automatically by default. Selecting the Check for Updates Automatically option allows users to run update checks instantaneously. This feature cannot be disabled.

In addition, an HTTP proxy may be configured. This proxy setting only applies to the Update Availability Detection option.

 

Copyright © 2016. Tenable Network Security, Inc. All rights reserved. Tenable Network Security and Nessus are registered trademarks of Tenable Network Security, Inc. SecurityCenter Continuous View, Passive Vulnerability Scanner, and Log Correlation Engine are trademarks of Tenable Network Security, Inc. All other products or services are trademarks of their respective owners.