Install Waterfall

Waterfall provides on-site installation and configuration, please contact Waterfall Support Center for further assistance.

Below is a basic configuration for a Waterfall Ethernet Multicast channel.

Note: According to customer’s needs and architecture, different channels may be required. Different channels may require different installation and/or configuration steps. Please contact Waterfall Support Center for any assistance.

Tenable Channel

Configure the TX Agent

  1. Click the Waterfall Configuration icon to open the Waterfall Configuration tool.
  2. Under the Stream section in the navigation tree on the left, choose the Ethernet Spoofing channel.
  3. Copy the Channel name: the same name must match on both TX and RX Agents.
  4. Under Adapter, from the Name drop-down menu, select the Network NIC.

    Note: This assumes the Network NICs have been assigned a valid IP for both the TX and RX hosts. This is normally configured during the initial Waterfall installation.

  5. To add protocol or port filtering, add the required protocol and/or port into the Filter expression field. For example:
    • Single filter: tcp port 80
    • Multiple filters: tcp port 80 or tcp port 23
  6. Click Apply.

Configure the RX Agent

  1. Click the Waterfall Configuration icon to open the Waterfall Configuration tool.
  2. Under the Stream section in the navigation tree on the left, choose the Ethernet Spoofing channel.
  3. Ensure the Channel name matches the TX Agent name.
  4. Under Adapter, from the Name drop-down menu, select the Network NIC.

    Note: This assumes the Network NICs have been assigned a valid IP for both the TX and RX hosts. This is normally configured during the initial Waterfall installation.

  5. Under Target addresses, check the following boxes:
    • Keep MAC
    • Keep IP
    • Keep Port
  6. Click Apply.