Tenable.sc Patch 202004.1 Release Notes (2020-05-05)

Tip: Tenable rebranded SecurityCenter as Tenable.sc. For more information, see the announcement.

Apply this patch to Tenable.sc installations running version 5.14.1. This patch resolves an issue in Tenable.sc 5.14.1 where attempting to generate a debug file with the Strip IPs option enabled would result in an error.

Contents

  • FilesystemLib

Steps to Apply

Apply the patch to your Tenable.sc, Tenable Core, or Tenable Appliance deployment.

Apply the patch to a standalone Tenable.sc or Tenable Core:

  1. Download the patch from https://www.tenable.com/downloads/tenable-sc to Tenable.sc. You can save the files in any location (e.g., /tmp).
  2. Access the command line as a user with root-level permissions.

    Note: If your organization does not have root-level users, contact Tenable Support for assistance.

  3. Run the following command to untar the patch file:

    tar zxf filename.tgz

  4. Run the following command to change the directory to the extracted directory:

    cd directory

  5. Run the following command to begin the installation:

    sh ./install.sh

    The installation runs and finishes.

Apply the patch to a Tenable Appliance:

  1. Enable SSH access, as described in SSH User Access in the Tenable Appliance User Guide. If you are running a Tenable Appliance version earlier than 4.4.0, contact Tenable Support for assistance.
  2. Download the patch from https://www.tenable.com/downloads/tenable-sc to your Appliance. You can save the files in any location (e.g., /tmp).
  3. Run the following command to untar the patch file:

    tar zxf filename.tgz

  4. Run the following command to change the directory to the extracted directory:

    cd directory

  5. Run the following command to begin the installation:

    sh ./install.sh

    The installation runs and finishes.

Filenames and Checksums

Filenames and checksums are located on the Tenable Downloads page.