License Requirements

Tenable.sc does not support an unlicensed demo mode. License keys are required for Tenable.sc and for all attached Tenable products.

You configure your Tenable.sc license and other Tenable product licenses during quick start, as described in Quick Setup. To edit your licenses later, see Add a License.

Tip: For information about Tenable.sc-Tenable product registration server communications encryption, see Encryption Strength.

Your Tenable.sc License

Tenable.sc licenses are valid for a specific hostname and for a maximum number of active IP addresses. Assets are counted towards your license limit depending on how Tenable.sc discovers, or sees, the asset. In general, an asset does not count against your license limit unless it has been assessed for vulnerabilities.

For example, if you purchase a 500 IP address Tenable.sc license, you can perform host discovery on your network but you cannot assess more than 500 IP addresses. For more information about discovery and assessment scanning, see Scanning Overview.

Tenable.sc generates a warning in the web interface when you approach or exceed the license limit. To monitor your license limit, use the the Licensing Status widget, as described in Overview Dashboard. To upgrade your license, contact your Tenable representative.

Counted Toward License Not Counted Toward License
  • IP addresses from active scans
  • IP addresses from Log Correlation Engine instances
  • IP addresses from NNM instances not in discovery mode

  • IP addresses from Industrial Security instances

A single IP address counts once toward your license, even if it was scanned by multiple methods or stored in multiple repositories.

Note: If you use an alternative port scanner, Tenable.sc counts the detected IP addresses against your license.

  • IP addresses present only from imports to offline repositories
  • IP addresses present only from NNM instances in discovery mode
  • The following excluded plugins:

    Nessus — 10180, 10287, 10335, 11219, 11933, 11936, 12053, 14272, 14274, 19506, 22964, 33812, 33813, 34220, 34277, 45590, 54615, 87413, and 112154.

    NNM3, 12, 13, 18, 19, 20, 113, and 132.

    LCE — 800000 through 800099.

Your Tenable.sc Continuous View Product Licenses

If you want to use Tenable.sc with other Tenable products, you must add their activation codes to Tenable.sc. For more information, see Add a License.

Your Lumin License

If you want to view and analyze your data in Tenable.io using Lumin, you must acquire a Tenable.io Lumin license for use with your Tenable.sc deployment. For more information, contact your Tenable representative.