Log into the OT Security Management Console

To log into the OT Security management console:

  1. Do one of the following:

    • Connect to the Management Console workstation (for example: PC, laptop, and so on) directly to Port 1 of the OT Security appliance using the Ethernet cable.

    • Connect the Management Console workstation to the network switch.

    Note: Ensure that the Management Console workstation is either part of the same subnet as the OT Security appliance (192.168. 1.0/24) or routable to the unit.

  2. Set up a static IP to connect to the OT Security appliance as follows:

    1. Go to Network and Internet > Network and Sharing Center > Change adapter settings.

      The Network Connections screen appears.

      Note: Navigation may vary slightly for different versions of Windows.

    2. Right-click on Local Area Connections and select Properties.

      The Local Area Connections window appears.

    3. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.

      The Internet Protocol Version 4 (TCP/IPv4) Properties window appears.

    4. Select Use the Following IP address.

    5. In the IP address box, type 192.168.1.10.

    6. In the Subnet mask box, type 255.255.255.0.

    7. Click OK.

      OT Security applies the new settings.

    8. From your Chrome browser, navigate to https://192.168.1.5.

      The Welcome screen of the setup wizard opens.

      Note: Access to the user interface requires the latest version of Chrome.

    9. Click Start Setup Wizard.

      The setup wizard opens with the User Info page.

What to do next

User Info