Auto Location Creation
Auto Location Creation controls whether the server automatically creates a new Location when a Tenable Patch Management Client registers with an IP address outside the IP range of every existing Location.
-
On-premises servers enable Auto Location Creation by default.
-
SaaS servers disable Auto Location Creation by default. Configure on-premises client detection before you enable it.
Auto Location Creation Settings
Configure the options described in the following table.
| Setting | Description | Type | Default |
|---|---|---|---|
| Auto Location Creation Enabled | If disabled, the server creates clients outside existing Locations as Internet Locations. | Toggle | On (on-premises), Off (SaaS) |
| Default Parent Location | The parent Location of new auto Locations. | An existing Location | Central Office |
| Default Location Type | The type of new auto Locations. | Default, VPN, or WiFi | Default |
| Metered Connection | Specifies whether new auto Locations are metered connections. | Toggle | Off |
| Allow Direct CDN Download | Specifies whether new auto Locations can download content directly from CDNs over the internet. | Toggle | Off |
Allowed Auto Location IP Ranges Settings
Configure the options described in the following table.
| Setting | Description | Type | Default |
|---|---|---|---|
| Restrict IP Ranges | If enabled, the server creates auto Locations only for clients in the specified IP ranges. | Toggle | Off |
| IP Address Ranges | The allowed IP address ranges. You can create multiple ranges. | IP ranges | None |
Configuring Auto Location Creation
To configure Auto Location Creation:
-
In the side bar navigation, go to Assets > Locations.
-
From the More dropdown, select Auto Location Creation.
-
If it is not already enabled, turn on Auto Location Creation Enabled.
-
Change the default settings as needed.
-
Select Save.
Restricting Auto Location Creation to Specific IP Ranges
To restrict Auto Location Creation to specific IP ranges:
-
Turn on Restrict IP Ranges.
-
Select +Create IP Range, enter the subnet ranges, and then select Create IP Range.
-
Select Save.