On-Premises Client Detection in SaaS

By default, a Tenable Patch Management SaaS installation creates Internet Locations based on the public IP address of each connected device. On-Premises Client Detection enables the SaaS tenant to contact devices inside your network so the server can determine whether a device is on that network. You can then create Locations as if the server were on-premises.

On-Premises Client Detection is an advanced setup. Contact Tenable Support for assistance.

Default Behavior

Without On-Premises Client Detection, the server behaves as follows:

  • A new public IP address creates a hidden Internet Location, configured as WiFi, that contains all devices with that public IP address.

  • Remote clients receive their own Internet Location and obtain content directly from the SaaS server.

This behavior works for smaller or mid-sized companies with simple networks. It can be inefficient for larger companies with complex networks, thousands of devices, or isolated servers and workstations.

Configuring On-Premises Client Detection

To configure On-Premises Client Detection:

  1. In the side bar navigation, go to Assets > Locations.

  2. From the More dropdown, select On-Premises Client Detection.

  3. Configure at least one of the following detection settings:

    • ICMP Target: The client is on-premises if the server receives an ICMP response. Select Hostname or IP Address, and then enter a device that the Tenable Patch Management Client can ping.

    • DNS Targets: The client is on-premises if any given DNS name resolves to the given IP addresses. Enter a DNS Target and select Save DNS Target.

    • Public IP Ranges: The client is on-premises if its public IP address falls within a specified range. Select +Create IP Range, enter the range, and select Create IP Range.

  4. Select Save.

Adding IP Ranges to the Central Office Location

The IP range should be a central point on the corporate network that every device can reach when it is on-premises.

To add IP ranges to the Central Office Location:

  1. On the Locations tab, select Edit from the more options dropdown next to the Location.

  2. Select +Create IP Range.

  3. Enter the IP ranges of the Internet clients that you identified in the detection steps.

  4. Select Create IP Range, and then select Save.